Using the ST7735 TFT Display with the Arduino Nano
In earlier Arduino based projects I’ve used two different monochrome LCD screens, but these were quite limited in their display capabilities. In the drop controller I went with the two […]
Read moreBuilding a Motorized Macro Rail: Part 2
Picking up from where part 1 of the Motorized Macro Rail project left off: Design Modifications I’ve made few improvements to the prototype design for the “production” version, as outlined […]
Read moreWhen it all goes wrong – 3D Print Layer Shifts
Printing one of the last parts for my motorized macro rail last week I noticed that the print quality had suddenly taken a major step in the wrong direction. The […]
Read moreArduino IDE Serial Port Issues
Getting back to developing on Arduinos recently after a bit of a gap, I was immediately hit by problems uploading code onto my Arduino boards. Obviously this was very frustrating […]
Read moreBuilding a Motorized Macro Rail
The Prototype Taking a (semi) objective look at this site recently I realised that it’s ages since I built a project with an Arduino. That’s certainly not because I’ve built […]
Read moreBack to Basics: the Dog Bowl Beauty Dish
While I’m waiting for parts for the stepper motor-based design I’m working on, I thought I’d take a quick trip back to basics. My first DIY photography build was a […]
Read moreHow to Use Arduinos to Drive Stepper Motors
I have a few stepper motors that were either bought or salvaged with the intention of using them for project builds. Since I’ve finally got round to starting work on […]
Read moreImproving the Slide Digitizing Experience
Back in 2020, during the first UK lockdown, I put together a slide digitizing rig. At the time I had to use materials I already had around the house as […]
Read moreTime for some Scavenging
Well it’s January – traditionally the month where everyone’s feeling a bit poor. So my first post of the year is about how to to replenish the parts bin without […]
Read moreHow to Add a Webcam to OctoPrint
In my last post I covered getting OctoPi/OctoPrint installed and configured on a Raspberry Pi to provide remote control and monitoring of my 3D printer. The next step is to […]
Read more